Fiber Optic Line Extensions and Modems

Four Channel DS1
FT2ER Quad DS1 Fiber Optic Extension

Four Channel E1
Model FE2 Quad E1 Fiber Optic Extension for International Applications



For over 25 years CXR Larus has been a leading fiber optic equipment supplier to the telecommunications community. We provide cost-efficient optical solutions to everyone from major carriers to the smallest enterprise application. Typical CXR Larus fiber optic products convert electrical DS1 or E1 into optical signals for transport through single mode or multimode fiber cable. These are used for the interconnection of LANs and WANs, extending the local loop, or used in the customer premises network in order to extend a LAN to LAN connection.

_______________________________________________________________________________________________

Model FT2ER Quad DS1 Fiber Optic Extension

The CXR Larus Model FT2ER local loop lightwave extension for metallic T1 is a four-channel DS1 multiplexer/demultiplexer that operates with full protection on the fiber (network) side.

An end-to-end Model FT2ER Quad DS1 Fiber Optic Extension System is comprised of the FT2ER circuit pack and mounting shelf at each terminal end and the interconnecting fiber. A fully protected system requires two FT2ER circuit packs at each terminal end. The units operate with either single or multimode cable, with distances of up to 39 miles (63.3 km). They are also ideal in pedestal and CEV environments, and operate over a temperature range of -40 to 75 degrees C.

Ordering Information:
FT2ER-1 Quad DS1 Fiber Optic Exension Module
1187-1 Mounting Shelf, 19/23 inch, holds up to 10 (5 pairs) of modules
1188-3M/F WL1 Mounint Shelf, 19/23 inch, holds up to 14 (7 pairs) of modules SPECIAL ORDER- CONTACT FACTORY
1189-0 Mounting Shelf, Remote, Desktop or Wall mount, holds 2 modules

Click here for FT2ER Data Sheet.

.. ..

Model FE2 Quad E1 Fiber Optic Extension for International Applications

The Larus Model FE2 is a local loop or short haul lightwave extension for metallic E1. This four channel E1 multiplexer/demultiplexer operates over a single mode or multimode fiber optic cable.

The Model FE2 Quad E1 Fiber Optic Extension delivers four E1 signals over a fiber-to-metallic interface. Fiber span lengths are up to 63 kilometers (39 miles) over single mode fiber. The FE2 provides the long span lengths required to make fiber optic loops cost-effective and practical.

Ordering Information:
FE-2 Quad E1 Fiber Optic Exension Module
1187-1 Mounting Shelf, 19/23 inch, holds up to 10 (5 pairs) of modules
1188-3 Mouning Shelf, 19/23 inch, holds up to 14 (7 pairs) of modules. SPECIAL ORDER, CONTACT FACTORY
1189-0 Mounting Shelf, Remote, Desktop or Wall mount, holds 2 modules

Click here for FE2 Data Sheet.

.. ..

________________________________________________________________________________________________





________________________________________________________________________________________________

 

Products
GPS and Cesium PRS Products
Network Access and Fiber Products
Fiber
NextGen NTP /PTP IEEE-1588 Products
Stratum 1 SSU/BITS Products
Test Equipment
Timing Restoration Kits
Transmission Products
i-ntarsia managed site